Keeping your e-match shroud on

[Pyrojoy]

Hi All
I wanted to post a short video on what I learned on keeping the shroud from coming back and how I keep my ematch from coming out when there is a lot of blackmatch in the e-port. I believe using this helps in it not being mandatory to buy e-match with shrouds that will not pull back. In all we must be careful at all times when inserting an e-match. Thanks

https://youtu.be/jJNn3TQjj74

[Kenny East]

Never thought about doing that to keep the shroud on, suppose it will work. Just don't twist it too hard

[cherrybomb1]

I had the same problem with a few of the Mjg firewires .All I did was pull the fuse back a little and they went right in then I wrapped the wire around the connector like they show in there video and wrapped masking tape around everything.

[cherrybomb1]

Also someone on the forum(don't remember who)said they skipped the connectors altogether and just put the fuse in the shroud taped it and had no issues.

[Pyrojoy]

I used the visco as an example but the tip was for blackmatch with a connector.

[cherrybomb1]

sorry pyrojoy I got to thinking about that since I was in the display forum.keep up the good work!

[Pyrojoy]

sorry pyrojoy I got to thinking about that since I was in the display forum.keep up the good work!

Np and thanks helps keep me straight lol