PYROLAMAS - another way to use them

[topshelfpyro]

52975298

Shot some 62mm test items and other things so I could see them in person. Just referencing another way to use pyrolamas extrusions. Could have used 2x as many holders but didn't need them so spaced them out. In the background you can also see a Craigco rack. Very good stuff there as well! (Pic was taken after everything was shot)

[mrsander7x]

Did you have to secure those down at all or was it heavy/wide enough on its own?

[topshelfpyro]

Oh the holders I make, they slide in the extrusions like the x holders

[mrsander7x]

Sorry, meant the whole setup - extrusions and all. Do they rattle around at all (during firing) in the flat layout or do the locking tabs keep them pretty secure?

[topshelfpyro]

Sorry, no it stayed where I laid it down. The locking tabs keep the extrusions together pretty well. All the force is vertical. Not sure if it would be different just laying on the ground. That is a 3/4" piece of ply underneath. I may actually drill and countersink the ends to screw it to the board next year when I use it.